14kt White/Yellow Spring Ring Guard Adjuster Large 4-5mm

Product Description

14kt White/Yellow Spring Ring Guard Adjuster Large 4-5mm

4-5mm – Thick banded men’s rings or extra wide bands.Fit shanks up to 5mm.

How to install a ring guard:
Following are the three easy steps to install a ring guard:

Step 1
Once you have your counter loc ring guard in hand you can install it into your ring. Holding your ring upside down, place the counter loc guard inside with the smooth side facing up toward the top of the ring. The prongs on the guard should come out on same sides of the band.

Step 2
ring wrap
Hold the ring guard in place and use your jeweler’s pliers to gently fold one prong down and wrap the prong around the band like this. The prong should fit snuggly around the band but not cut into the metal. When the first prong is in place, fold down the other prong and wrap it around the band as well.

Step 3
how to size a ring
Once the prongs have been secured around the band, you’ll need to try your ring on.

If it is too tight now, remove the ring and push the counter loc bar down to bend it closer to the band. Try your ring on again and repeat this process until the ring fits just the way you want it to.

Finished!

Follow Up:

Once the ring guard is in place you may adjust the ‘size” of the ring. Just push up (or down) on the middle band of the ring guard to tighten or loosen it on your  finger.